mahindra 5525

I've just joined this forum to get some help with this problem, which I see is a fairly common issue with Mahindra tractors. The tractor in question belongs to my gliding club and is used for maintaining 30 acres of grass runways. The fuel gauge, temperature gauge, tachometer and the digital...

Please forgive this embarrassing question, but the owner's manual just isn't clear to me. Where does one check the hydraulic fluid level on the 5525? There is a red topped plastic cap just behind the driver's seat on the right above the PTO labeled "OIL" and "Misseli" on it. It has no dipstick...

PTO pops out. Lever will not stay engaged. does not feel as if it is latching properly. Also will not latch in neutral position to engage ignition interlock switch. Just happened while mowing. Need input on how hard to tear down and repair.

I recently purchased a 2011 Mahindra 5525. The question I have is about the brakes on this tractor. When I have it in gear and press the brakes the tractor does not stop, it bogs it down slightly but it just keeps going. I have to put into neutral first then hit the brakes to get it to stop. I...

Hi everyone, I think after 7 years I might have done the unthinkable, I ran my tractor out of diesel and now it wont start. I'll tell you now, I am not very mechanical, but I can turn a wrench when I need to. To make a long story short, my gauges quit working about a year or so after I bought...

All Hydraulics are sluggish front loader and the 3pt. Filter and oil was changed about 2 months ago, just use it a couple weeks ago to move roll of hay. Just today dropped the roll fork put on auger, the Hydraulics went sluggish It a Mahindra 5525 2007

I'm planning on draining my coolant tomorrow. The manual says there's a drain plug on the left of the crank case and one at the bottom of the radiator. The plug on the left side is easy to find and get to, but I can't find the other one. Can anyone point me in the right direction to find it?

I will be purchasing a new Mahindra 5525 for a small hay operation and wanted to know if the FEL will handle a 850 pound bale grab + 600 pounds of square bales in it. I know the loader capacity is there but will the tractor have enough mass and weight to handle a object as large and cumbersome...

What kind of hydraulic fluid do I need to use for a Mahindra 5525? Thanks

I'm looking to fit my 5525 tractor with a valve like Flusher's shown on the photos, I take it this would be an OC valve with power beyond and I would want to use double acting cylinders, which detent would I need...spring to center? How would this be plumbed to the tractor with a front end...

I have searched the internet for hours looking for a book, dvd, program etc..for a quick tutorial re using a backhoe. All I found was tech schools and ojt. type sources. Anybody have a source for my quest? I know that experience and hands on will eventually prevail, but looking to get the...

It seems today's tractors are a Heinz 57. The motor from one country, the transaxle from another, etc. Anybody know what motor is in the 5525 and what transmision. The Italian tranny that is in the 4110 is no the same as it is limited to 43 HP. I've seen Daedong motors and they seem to be clean...