mmm

I've been mowing with Kubota CUT's with 5 ft MMM for 16 years now. I usually clean up (not grease) the MMM and the tractor after every usage. I'm getting older now and want to cut back on greasing if possible. Right now I grease about every 10 hours of mowing...that is about 3 mowings of...

Casting that holds lower seal/bearing/seal combo (upper is gear). The edge, that happens to guide a O-ring so grease can travel through, corroded away, for 3/8s or so, right where it should support the grease O-ring. I 'rebuilt' it with JB Weld, but wondering if it is a 20 year old missed, bad...

I just bought a 2023 emax 20s with loader, backhoe and third function option. I want to add the 54 inch MMM. I saw a thread that said the MMM would not work with the backhoe? I have seen other emax 20s with loader, backhoe and MMM for sale so I think that is wrong and I can configure a new 20s...

Hello everyone, I have been gone for some time from the forum and of course I come back needing help. I traded my 19 year old B3030 for a new LX4020 this summer. This weekend I took off my 72" MMM to put the loader and land pride plow on. I have read the manual a thousand times and can not...

Have any ideas for taking blades off and sharpening? CS 2220 60" deck. My old JD Ryder I could pretty well slide it out and flip it over. This one not so much.

I can't see a way to get to it while mounted. Might be possible with a 90 degree fitting so I have one ordered. But I got to wondering about if it might be possible to drill a hole in the tractor floorboard directly above it and use a longer fixed tube. I haven't explored it yet to see what...

I've always taken my MMM off in late fall prior to putting on front blade for plowing. The 72 inch deck is a monster to move around and store. So I was thinking of just pinning it up and leaving it on for the winter while plowing. Has anyone else done that? I not sure what harm it can do...

I own a Mahindra Max 24, and am having midmount mower deck hydraulic lift issues. I have both removed and attached the MMM many times throughout the years without issue, but this springtime attachment has me puzzled. The MMM shares the same link functionality with the rear 3PH, and is supposed...

Quite some time since posting here, but good CUT info so give it a go. Does anyone know if M02732 and M02734 deck shells are similar enough to swap spindles, gearbox and mount hardware? Basically switch all parts from the older M02732 deck to the newer type M02734? TIA Mac