pipe

Hi all, I'm installing a 30" HDPE culvert pipe. Nearby I have an existing 8" PVC runoff pipe that I'd like to tie into the 30". Should I use a T with Marmac wrap and use reducers. But without using reducers, any way I can cut a hole into the 30" pipe and stick the 8" pipe into it and use foam...

I have a Hobart 210 mig welder with a generator. I am building a perimeter fence and using oil field pipe and sucker rods on the corners. If I use flux core wire (.35), do you think this will work without it breaking continuously? Don't really want to break down and buy a gas powered stick...

Greetings all, I have a leaky delivery pipe. The pipe comes from the HST to the FEL. The part number is 13025134600. I can't find any where that has it. Tractor is a T353 HST. #8

The seasons are turning as fall quickly approaches. Time is running out for many projects, one of which is heating my shop. Last year I bought a kerosene/diesel forced air jet engine heater. It worked well, rising the temps up to a comfortable level during the depths of winter. But those heaters...

20 years ago I imported a B21TLB to Sweden from the US. The machine has been incredible problem free. However, yesterday I identified a hydraualic oil leek coming from the oil cooler return pipe located at the third bend counted from the front. A section of the pipe is corroded and the leak is...

Two marmots took up residence behind my rear barn. That's bad news since they will burrow under foundations, etc. Plus multiply. The other day, they ran into a 8" irrigation drain pipe with only one opening. I sealed it off and trapped them in. I occasionally see them through a metal grate at...

Bought a new muffler on Ebay. Went to a local metal fabricator and had him create a new exhaust pipe. He did a really good job ! It's noticeably quieter than it was before. He also fab'd a nice heat shield.

Hi Guys, I'm in Canada, and looking for a 12mm pipe plug/drain plug socket for the 4 drain plugs on the T25 front axle. Im not a fan of using open ended crescent wrenches on hard to remove plugs, inevitably they get gauled up Looking everywhere I cant find a 12mm. I find 10mm and lots of...

Hey guys, running my Mahindra 2538 HST pretty hard today and all of a sudden I heard a small pop and noticed hydraulic oil pouring out. I was able to drive it back to the garage after adding some fluid, but still leaks pretty bad. It appears that the leak is coming from the flare on the pipe...

I need about 600’ of tubing, and I found a vendor that had it for under $900—- but the shipping was almost $800! our local plumbing supply houses do not stock it and tell me 6-12 weeks to get it in. we are in Western North Carolina. Any suggestions? THANK YOU!!!

DISCLAIMER: YES - I WILL TAKE AND POST SOME PICS LATER TODAY - Our lot is in a little dead-end valley, and the part that will be farmable once I clear it out - it has not been tended in 50+ years, and there are a good number of substantial trees that need to come down first. Up on the...

hoping to get my water line run to my wellhead before the ground freezes more than an inch or three ... I have a ck2610 on its way, with backhoe and FEL (so ~~4000lbs), industrial tire tread. Its arriving 1st of November, so in my area it's be close, temperature wise, for the days to fully...