regen

So, I have a new tractor being delivered tomorrow. It’s a Branson 5520C with TYM badges. It’s my 3rd Branson. 4220i, 5220C, and now the 5520C. The previous Bransons never had any regen/emissions. Can anyone describe problems, if any, you’ve had with the regen? I’d like to know what I just got...

I have a 2020 X.135 with the Kukje engine. It has 250 hours on it. I know in the beginning, I was not doing what I was supposed to do by keeping it at a higher idle. I had performed a few regens on it and never had an issue. However, this winter, it started to "de-rate" itself for any use, PTO...

We have a Workmaster 33 bought in 2017 which now has 120 hours. The red exclamation point engine warning light and the regeneration lights are blinking and the tractor won't go above 1800 RPM. I have read that this may be due to failure to regenerate the DPF and/or there may be error codes...

2014 XR4040H 900h. Regens every 4 hours. 2-3 cycles ago the Regen cycle lasted 2 hours then back to normal. Now the Regen won't turn off. I was Regen and running the tractor at 2000rpm. Now if I Regen at 2k RPM the warning lamp comes on and the Regen cycle stops mid process. If I keep the RPM...

Hello, My XR4040 was just completely gone through by the dealer at 500 hrs. Over the past few weeks I hired some yard guys for tress trimming, etc. a lot of work was done at low RPM (I know…higher RPM). In any event, the tractor went into limp mode and 1700 max RPM. I tried forcing Regen but...

So this is something new....it needs to regen pretty much daily now...it has 300 hours on it, 2016 bought it. Been doing alot of loader work and its highly annoying burning diesel on regen and walking away for 40 minutes to regen Any ideas?