solution

I needed to make two aluminum door frames for our greenhouse. I have a machine shop so I milled the corners to exact 45 degree angles. The material is 3/16 thick angle with 1.5 inch legs. After milling the material I beveled the corners on the back side for good weld penetration. I left about...

Quick back story: My BF decided to upgrade Jane Deere, a 2002 990. She was primarily used for putting out hay rolls every week the last few years. Before that, some mowing and bush hogging. She lived outside her entire life with 3 different owners, wasn't in bad shape but at the very least, in...

So this is a problem I’ve had washing my car at home. We have three vehicles one of which is a Dodge Challenger that is black. It’s the car that wants to spot from hard water. I recently bought a foam cannon and use a wash and then a rinse product that helps, then immediately pull it in my...

There are a variety of communities where people are able to mark "issues" solved. it edits the original post with a solved solution link to the thread that fixed the issue. would that be possible here? I think a lot of people would appreciate it when searching etc.... @Muhammad