tc33d

My TC33d has hydraulic leaks at weep hole, it loses a lot of fluid. I saw a post where someone thought that o rings might be bad on tubes in the area, but no resolution. I wonder what could cause this. It does seem to be worse when using the loader. Has anyone fixed this?

I may be selling my tractor and wonder what it is worth for sale or trade in. It has about 2300 hours on it, hand throttle cable just broke and the parking break needs a new cable as well. Other wise every thing works great and has been a great tractor. I want to upgrade to a heavier tractor to...

Where can I get a good set of replacement hazard lights for a 2001 TC33D? One thing I liked about the original lights was that the base had a sort of spring-loaded flexible mount, so the light fixture could take a hit and just bend over, then bounce back up again. I've finally beaten mine to...

I have a 1999 TC33D that just got an hydraulic pump job and the mechanic left the battery cables disconnected. I mean the ground cable (battery negative cable) is completely off the tractor. Now that cable is fairly short (maybe 18 inches) and based on the position of the positive cable the...

Hoping some one can give me a tip. Once my tractor is warm it starts fine. However, when it is cold i will only hear a click most of the time. It is a new battery, solenoid and starter test fine (ie if I short it out). The starter is getting over 12v from the battery, when I measure the s...

I just purchased a 7308 loader for my TC33D. I mounted the control and piped down to the quick connects. This is the diagram I followed. I hooked up and it doesn’t work. I am assuming that I have the metal pipes from the controller hooked up wrong since my brake pedals hit the pipes. Any input...

Hello, I have a mid mount mower deck on my TC33D. I plan to use a blade with the tractor. Clearly since the mid mount raises via the 3pt lift arms I need to remove the mower deck so it does not go down with the blade. To remove the 914A mower deck pins can be pulled and the link arms can be...

I am adding summit rear remotes to my TC33D tractor. Unlike most I decided to not use the PB from the FEL. I found a thread where you can add a Tisco HV4945 adaptor plate to tap into the PB where the new Holland stock Rear remote would plug in. I liked that idea better than running hoses back to...