tc45da

My ROPS lights are in bad condition and I am replacing them with LED lighting. I labeled all the wires prior to cutting the factory lights off. My question though is do the red lights (on bottom and only facing to the rear) do they flash when the hazards are turned on?

Hey all, I've been using these forms for a while, but I'm a new member, checking to see if anybody has a New Holland TC45DA, for or a t2320 for sale that they would be looking to part with, I haven't had much luck being around when they come up for sale at auction, seems like they go for sale...

Today I went to use TC45DA and its 250TL loader. The loader went up fine and lifted a log splitter without issue, but wouldn’t lower the load when the joystick was pushed into the lower position. However, when I pushed joystick into the float position it lower as I would expect it to. I...

Aside from a grapple has anyone found any hydraulic FEL attachments for the TC45? I would love to have a concrete mixer, but it looks like the flow rate required is too high.

I don’t know what these two electrical plugs are for in the first two attached pictures of my TC45DA. Also, in the last picture which one is the flasher for the hazard lights?

What filter are you us for the smaller hydraulic filter on the left side of the engine (looking from seat)that is readily available? Also, is this a low pressure filter? NH part number is SBA340501030 (says it has a bypass valve), I couldn’t a cross reference on Baldwin Filters site that is...

What are you guys using for coolant when you have replaced it? The manual calls for ESE-M97818-D, Ethylene Glycol Coolant.

All, I noticed I my TC45DA is leaking/weeping hydraulic fluid. It looks like it’s leaking where the hydraulic pump bolts to the front cover of the engine and it’s not engine oil. Is there a chance that the hydraulic pump is just loos and that tightening the bolts will slow or stop the flow? I...

My TC45DA factory loader at time drifts down while I am using it. Is this an indicator that the loader valve needs new o-rings/seals?

All, Just noticed that my hydro drive TC45DA’s electric two speed is not shifting when switched. The light changes from turtle to rabbit and back, but the ground speed doesn’t change. I just cut some really tall weed/brush and it was working then, but this weekend it wasn’t. I gave it a...

I ha a broken red lens on my tail lights and it seems the lens is no lo made. Has anyone replaced there TC series tail lights with some kin of standard trailer led lights? I would assume I may need to swap to a flasher compatible with led lights as the stock lights are incandescent bulb.