terramite t5c

Hi Guys I looked through the forum and saw some posts on towing a terramite T5c. I am still somewhat confused on how you get the hydrostatic tranny to free wheel.. Can someone provide the information and maybe a picture of where or how to bypass. Thanks in advance. Pat

I've acquired a terramite t5c backhoe. I installed a new carburetor and fuel pump and the motor runs really well. when taking off there seems to be a whining noise from underneath. It goes down the road fine but whining has me concerned there might be something wrong. I've never had this type of...

So I have been looking for either a TLB or small back hoe like a terramite. I知 looking for a piece of equipment for removing stumps, land clearing, and general drainage work. I知 also trying to stay in 1/2 ton towing range. I致e found a couple terramites T5C close by for around $5k both with...

I am rebuilding crowd cylinder on was looking at a post earlier to tear it apart it went well, however is there a tool I need to insert the piston back in the cylinder without ripping the seals, or any suggestions as to how to keep the, from tearing. Thanks

Trying to find year of my T5c backhoe . Serial # 2350304. I have looked on the net but no luck.

Hello, I started using a Terramite T5C today and was using it for about an hour. I turned it off for a few minutes and went to turn the key and nothing happens. The battery is good. Is there a safety switch somewhere or something else that could be causing the issue. Any help would be...

New to this group. My Terramite from the early 90s gave up the other day. I put a new camshaft and crankshaft in and the motor fired right up on my bench. Once I couple the motor to the hydro the motor won't turn over. I can spin the hydro with my hand but it seems like this extra tension will...

I am looking for rubber outrigger shoes or pads. I do alot of work around concrete and need a little protection for the ground.

I just bought a 96 t5c with 475 hours, does tractor supply sell anything for this. Are there any places that sell aftermarket parts for a t5c. I am looking for rubber outrigger shoes or pads. I do alot of work around concrete and need a little protection for the ground. Did terramite make a...

Hi everyone, Jim up here on Kodiak having an issue with a Terramite T5C locking differential. It seems to want to lock, yet one wheel will spin while the other tries to turn. This was purchased at auction and has 1200 hours on it. I like the machine a lot, very bush friendly and powerful for...

Hi everyone, Jim up here on Kodiak having an issue with a Terramite T5C locking differential. It seems to want to lock, yet one wheel will spin while the other tries to turn. This was purchased at auction and has 1200 hours on it. I like the machine a lot, very bush friendly and powerful for...

ok,, i had had this thing apart so many time and still cant get it from flooding .. i have installed a new float, new needle , played with the foat settings , .. no matter how i set this thing it still floods out to the point of having to take the plugs out to turn it over .. i will be doing...

anyone know who I could get some frt bucket teeth for my 4 ft bucket on my terramite. Could be the pin type or chainable. Do I hav to buy the separate through Terramite?

anyone have transmission numbers for eaton or cessna for hydro state replace part that pedal forward or reverse is in thks

anyone have model numbers for eaton or cessna transmission replace thks

My T5c has a lot of clearence at the axle pin & boss at the front end axle weldment. Facing the tractor, clockwise and counter clockwise movement is normal for the axle but the clearence is so bad, it rotates front to back enough that the axle weldment hits the frame of the tractor. Does anyone...

Hey guys, I bought the tierods based on the factory service guy. I replaced them exactly like the others were installed.....but the angle is not right. Anyone have a picture of how yours is set up. Picture posted.....don't want to order one for the other side till I figure this out. It looks...

Hello all, After renting a terramite a few years ago and instantly won over by it. I had the great fortune to buy a T5C from a local equipment rental that went under. The T5C I purchased only has 745 hours on the clock but was missing a couple of parts { engine shaft coupler/bucket hydraulic...

I have a 1993 Terramite T5C with a power steering problem. The Kingpins are working correctly however there seems to be no hydraulic power to the steering cylinder from the pump. I can steer the tractor using the steering wheel however it is slow and difficult to operate the steering wheel. I...

hi I am new and hoping someone and tell me how to repair my terramite t5c. the hoe keeps slowly droping down all the time. not fast but slowly. as i use the machine i must reach back and pull the joy stick about every 10 to 15 min. so the hoe will not hit the ground. does anyone know why. thanks...

I want to install a Vickers Solenoid valve part #9-6136 from Surplus Center. to operate a single cylinder on a front end grapple I built for my Terramite T5C. Does anyone know if this valve can be installed in the supply line from the rear bachoe stack power beyond outlet that presently feeds...

Hello folks I have a T5C that now looks like popeye. Not sure how it happened but it's smashed out. These are the plasitc rectangular headlites. Does anyone know where I can get a drop in replacement? Also the hydraulic oil. I have read it is 15W40 motor oil. Is standard off the shelf...

Here's my terramite video review. Jims terramite t5c review - YouTube

I'm in Southwestern Ontario, Canada. We don't get many Terramites up here, used or otherwise. I'm considering buying one. Here's what I can tell you about it: - some of the cylinders leak - his current asking price of $8500 (Canadian dollars) is firm (he turned down an offer of $6000 for it...

New one to this great site and I知 starting to learn a bit as I am completely new to the tractor segment. I have a 6 acres, gradual hilly with lots of trees. I currently own a Hustler 60 ZTR mower that I absolutely love and I really don稚 want part with as it makes the mowing quick and easy...