three point hitch

I was using the front end loader to move debris with the three point raised on my MF 1240. After completing the task, I parked then lowered the three point and front end bucket. Next day, three point would not raise. Front end loader works fine. Hydraulic fluid checked good. I can see the lift...

1802d Three point hitch won't go down. I am looking for where the lockout assembly is located for a start. thank you!

Hey everyone, unfortunately my TC35D left me hanging. The three point hitch has stopped working. It will not lift any weight at all. At full throttle with no weight, it will very slowly lift, but just barely. Tractor has a loader and loader works great, when loader is unhooked, three point hitch...

Our Kubota M120 has a problem with the 3 point hitch. Sometimes the 3 point hitch works ok, but most it goes in "Lock" and neither cab controls or fender controls work. The 3ph height sensor and the draft sensor have been replaced but no difference. We worked through the WSM and all electrical...

I've been running my Kioti CK3510 for a few years with a land pride brush hog attachment. Suddenly, this summer, I have destroyed three of the lower 3-point draw pins. The cause is the same each time. The 7/8" nut vibrates off during mowing and with it goes the large 7/8" flat washer and...

Does anyone know of a good site to cross reference website for hydraulic lift control valves? I'm looking to rebuild New Holland hydraulic lift/control valve part # MT40007577 (LS Part #40250285). I have been able to cross reference some parts on New Holland tractors but I haven't had any luck...

About 3 month ago I changed out the loader control valve on my Kioti LK 3054 and after that my three point doesn’t work anymore. I’ve tried changing the seals in the three point cylinder turning off the loader controls with the shutoff valve to put all the pressure to the back and nothing seems...

I recently purchased a 1997 Kubota M4700 The 3 point hitch has 2 levers. One for position and one for draft control. It seems that the position control does nothing. The only way for me to move the 3ph is with the draft control. Is this normal? I'm not familiar with using draft control, but...

I am making a bed lifter implement and would like to talk about pin length for lower (or upper) arms of 3pt attachment. Take a look at these to examples. The important dimension is B. It is 5in(~130mm) in second image and 3 3/4in(~95mm) in the third. Since this is for category 2 tractor, I...

I need to weld the pin holes to the 3pt bar for lower link arms to attach. This is the pin that I got. It is a step pin for both cat 1 and cat 2 tractors. The dimensions are in millimetres. I'd like to double check if this pin is designed to be used with 3 connections or just 2? With...

Hello everyone! I am wondering if there is a standard specifying how much space should be between lower pin holes of the three point hitch and the bar for category 1, 2 and 3? Take a look at the image to see what I mean. From the book I am reading.. the standard specifies arm span and width of...