tips

I have a Rhino L200 9” PHD and it has stopped digging. I want to swap out the dull tip. I see 2 options: spiral point and fishtail. My soil turns to red clay at about 24 inches, rocks not a problem. Which point gives better results? Guadalupe County, Texas

I just bought a used Ford 770 loader with arms and hydraulics for my 1980 Ford 1700 and am looking for any advice for installing it. I've never done anything like this. The loader I bought came off a Ford 1300, which I gather has a slightly smaller clutch housing, meaning that I will have to...

Suggerimenti per cancelli di recinzione fai da te ciao dovrei costruire un cancello una barriera per chiudere l'ingresso del mio terreno. Attualmente lo stesso è chiuso con pali e rete metallica. Dovrei ripristinare la rampa di ingresso con un escavatore o una pala meccanica ma un passo alla...

Rather than revive a 4 year old 3d printer thread, I thought I would start a new one. My son is in a 3d printing club at school and seems really excited about it. He has always been a DIYer, has always LOVED building things There are some really capable and affordable 3d printers out there, so...

Every once in a while there’s folKs here looking for advice for themselves and their best friend (me included). I figure instead of derailing the dog picture thread It should have its owns. Feel free to share pervious issue and what you did to fix it! or your ongoing issues behavioural or simply...

Hey folks, figured this would be a good place to post as I know from reading here for a 10+years that there are some people that muscle through recovering from surgeries and find work arounds to getting things accomplished despite impediments. I'm 47 years old and am happily staring down the...

when I am mowing very tall thick reed grass, the tough cut will bog down. It works better if I raise it up (partial or maximum). Any problem with mowing with the deck raised up high on a first pass? Or should I only do that for short distance?

New to me 2 months ago 2018 KX71-3 I have spent a bunch of time getting rid of rust induced stiction so all the controls are very free moving. This has helped a bunch but the main track controls are still giving me problems. It feels like they move 3 inches and do nothing and then there is 1/2"...

I think its time to replace my anode. Past experience is it's a son-of-a-gun to break the anode loose using only a breaker bar. Does anyone have any tips to share and advice on using an impact gun?

I have a New Holland Workmaster 55 with cab. I periodically blow out the cab pleated air filters with compressed air after knocking them on one the tires. Are there other tricks I can use to extend the effectiveness of these filters. The damn things are expensive! Thanks!

Thought it might be nice to have this thread for us to share tips and suggestions to make ownership and operation easier for others. Some of these might seem like "no brainers" to seasoned tractor and implement owners, but to others they may be welcomed. Here's a few I've learned over the last...

This is infomation only so somebody wanting to purchase a tractor can get an idea of what they want and then start trying out the different tractors so you get the most for your money. Yanmar has some good discounts from $150 t;o $5,000 depends on what you purchase also a 10 year drive train...

Hi! Does anybody have any tips, techniques, or ideas on how to keep horse manure from freezing to the bucket on a backhoe? Wicked hard to chop it out if it gets frozen….(and it usually happens EXACTLY when you need the backhoe for something else, right!?!?) 😉😂 I’ve tried putting a layer of...