torque

Ive traced a glow plug issue to a bad plug. I desided to replace all 4….. once one goes…. I ordered 4 new ones, but cant find the proper torque requirements, and/or weather i need to use a sealant. Its for my 2010 DK45HSE Thanks for any help. I cant find the info in the service manual.

When I first installed a new head gasket on my YM240D, I was able to find a written specific sequence of head bolt torquing that was very useful. It showed the 3 torque stages, the specific nut sequence for tightening, and the number of re-torques and at what times. Is there such a thing still...

Waiting for an inner wheel bearing to arrive for my 15' flexwing mower. I already have the outer assembly. Memory from 40 years ago says: (after all is assembled correctly and greased up) 1. Tighten to an appropriate torque.... 2. BACK the nut off say, 1/2 turn then slide cotter pin through...

tl;dr = Anyone know what the correct wheel lug nut torque specifications are for the R4047H front wheels? The Operator's Manual tells me to "Check torque of wheel bolts and nuts," under the "First 50 hour check." Ironically, I cannot find any mention of any torque specs in the Operator's...

What's the torque ft lbs for a Mahindra emax 20 rear wheel.

I've got a Kubota B2789 snow blower. 3point, gear drive to the auger. The right angle drive to the auger has a shear plate fitting with a 1/4 inch shear bolt. Bought used, the previous owner was running this blower with about 1/4 inch gap between the shear plates. THAT"S not right! Bent the...

Can anyone here post a link for the Head bolt torque specs for a 2005 kioti CK25 HST? Many thanks!

Hello, I am looking for the torque specs for the front wheel hubs. I will be replacing the oil seal and would like to do this properly. Any information would help. Thank you.

Hello I'm new here I'm currently working on replacing the seals and bearings on the front axle of a John Deere 6220 SE and I can't find the torque specifications for the ring gear bolts. I've looked through several online resources but haven't been able to find the exact specs. If anyone has...

Hello, Had to get the tire / innertube replaced in town and now I'm trying to re install wheel onto hub but cant find the tighten specs for it. Thinking no more than 80 foot pounds. Your thoughts, Dave

Good day, I am running a logging implement on my NH TT4.90, and the unit is rated for 3000 to 3500Nm of torque (at 540rpm), while the tractor engine torque produced by the tractor at 1400rpm is 340Nm. I assume there must be a material increase in torque at the PTO at 540rpm due to the gearing...