won't move

  1. R

    1985 ym26 won't move

    A leaky gasket on the right rear of my tractor caused my brakes to seize. I recently had a mechanic friend replace brakes on both sides of the rear with new brakes, springs and gaskets. After everything was assembled, after putting it in gear it won't move. Unless the power inverter pedal for...
  2. G

    2011 JD 5065M won't move and throws a Red Ring light on dash.

    We have a 2011 John Deere 5065M 5 cyl. turbo cab model and it randomly stops moving. The red ring gear illuminates on the dash and it will not move until you put it in Park and neutralize the Power Reverser, turn off the engine and restart. It's very random and it has been in the local JD...
  3. B

    Tractor won't move

    HI: I have a2022 LS MT-125 with a backhoe and an FEL. I did the fluid change at about 53 hours as I was doing work at the 50 hour mark and wanted to finish the job. NOw with 56.4 hours, I was backing the tractor up after warming it up and it just stopped. Neither pedal would make the tractor...
  4. N

    TC35A won’t move

    Was mowing the roads, then moved up to a small field been rolling along a good 4 hours. I wasn’t mowing fast was in low range and third gear moving about 3 mph or so. Had made several passes. It’s starting to bog down a bit not too much it’s a big ant bed got past it rpm’s picked back up and...
  5. W

    TC35 shuttle shift won't move when in gear.

    Hi i'm sure this has been brought up before but i've not been able to find it. Our tractor has been sitting for the winter into summor and just now been able to get it running. But when I shifted into gear and let the clutch out. Nothing happens. Although if I push forward on the gear selector...
  6. jrailey470

    3 point won't move

    Just bought a ym3810d in good condition except for the 3 point doesn't seem to do anything, the guy I bought it from said he only used the tractor for the loader and has never tried to use the 3 point and didn't know it didn't work, I took a chance and bought it anyway hoping it was something I...
  7. P

    John Deere D140 won’t move

    I was mowing with my D140 and on my way up the hill I got the deck stuck. I smelled burnt rubber and all the sudden it wouldn’t move. I assumed the belt slipped so I replaced it, however it still won’t move. It will move a little if I push it while my wife pushes the pedal, but then it stops...
  8. D

    B1750 starts but won't move, just makes grinding noise when clutch is let engaged.

    I bought an older b1750 HST 4x4 a few months ago. I had been using it with no problems and backed it up to my tiller one evening, thinking that I would hook up to the tiller in a day or two. Although I had no problems when I parked it, I went to get it and hook up to my tiller but after I...
  9. K

    DAVID BROWN 995 Hydraulics stopped working

    I've had my 1975 DB 995 for 26 years. I have a Loader on it. I was Roto Tilling this AM. After pulling the Hand clutch to engage the PTO, I tilled approx 30 yards and then tried lifting the tiller. It would not come up out of the ground. I switch Hydraulics to LOADER, it would not raise...
  10. S

    John Deere 7610 won't move: code RCU 57

    I have had this JD 7610 (power quad w/ left hand reverser) for about 5 yrs and occasionally it will throw RCU code 57 and not move. Replacing the associated relay in the panel on the right side of cab under console normally gets it going. I have reached the point where that's no longer working...
Top