1520 and T110 FEL lift capacity.

[tractordog]

Hi,

The manual for my T110 FEL has a lift capacity listed for the 1520 at 770 pounds.

Is that realistic? With a quick at at the end and pallet forks do you think 500 might be more like it.

I may be picking up a five hundred pound load out of my pick up and was not sure.

TD.

 

[yooper1]

I have that loader on my T1510

I think the lift capacity is very light ....and less than what they say.

You can feel the loader strain with 3/4 or full bucket of dry dirt. Snow...it will handle, but dirt not so much.

Although...I easily lifted a Landpride RTA 1266 in the crate off my trailer with it...no strain at all. The Landpride site says the tiller weighs 448 lbs.

 

[yooper1]

also...you say you have a quick attach on your tl110?

I thought they were not available without making your own.

May I ask where you got yours from?

 

[tractordog]

I got it from the dealer this year. Did not know it was anything new for the 110. The plate on the 110 says it was built in 2009.

 

[yooper1]

thanks...I will have to see my dealer about one

 

[yooper1]

Just an after thought here, but are you possibly mistaking the "quick mount" loader assy for a quick attach bucket? There is a big difference.

The quick mount loader allows for the whole loader assy to be removed / installed in short time, but the bucket itself is pinned on and not a quick attach type.

The NH site does not show any quick attach options available.

http://agriculture.newholland.com/u...Compact-Tractors/Pages/products_overview.aspx

Do you have the quick attach and forks on it now?

If you do have a quick attach plate and forks, could I get you to snap a photo of it?

 

[tractordog]

I have never had the loader off,

Swap the bucket and pallet forks many times.

Will take picture when able. Too bad manuals are not online I could just point you to the page with the quick disconnect.

TD

 

[yooper1]

Thanks...I guess there is no need for a photo seeing as you have it and you got it from a NH dealer

I will just ask my NH dealer about it

Thanks again

 

[wny770]

I have a T1510 with the 110FEL. I used to move around my gas powered welder at 500 lbs, with rear back blade as ballast, with no problems at all. I too have the quick attach bucket, and I like it.