2800/3400 gear drive - pto lever schematic

[bigballer]

i have an hst with a sticky pto cable, i've replaced it, lubed it, adjusted it and it simply won't disengage fully without some manual intervention. i know the gear models have a lever down by the right foot to engage/disengage and i want to build a helper lever or replace my cable all together. does anyone know where i can get the schematic for the gear drive pto lever and associated parts? i would like to look at an exploded view to model my lever after.

 

[bullbreaker]

Did you try contacting Neil @ Messick's | Dealer for New Holland, Case IH, Kubota, Cub Cadet and More | Online Parts, Sales & Service.

Boone

 

[ccsial]

The gear models use a different type of PTO so it MAY have a lever that is not applicable to the HST. I have thought if I have trouble with my cable I would design a lever system. My 2005 with 360 hours is still OK.

The PTO will not disengage easily if it is not spinning. The rake angle on the clutch teeth prevent this. I always press the clutch in and disengage at the same time. It always disengages easily this way.