3 point hydraulics Max26

   / 3 point hydraulics Max26 #1  

vietvetharry

Silver Member
Joined
Dec 18, 2006
Messages
103
Location
Upstate SC
Tractor
Mahindra Max26XL Shuttle, Montana C4864
I had to remove the FEL to weld the support frame that broke. I looped the two hydraulic lines that were going to the FEL controller thinking that would keep the system closed, but now the 3 point will not lift. Do I need to bleed the lines or do I have to reroute the hydraulics differently? HELP please.
 
   / 3 point hydraulics Max26 #2  
Hi Harry, there should be 4 hydraulic connections to the loader and disconnecting those should be the only thing 'ya have to do.....

Joe H.
 
   / 3 point hydraulics Max26
  • Thread Starter
#3  
Thanks Joe, but I also had to remove the frame to have it welded and that required me to disconnect the joyshick and hydraulic lines. I capped the three connections on the hydraulic block that went to the FEL and the one that went to the rear for the backhoe. The 3 point still will not lift except by hand.
 
   / 3 point hydraulics Max26 #4  
Thanks Joe, but I also had to remove the frame to have it welded and that required me to disconnect the joyshick and hydraulic lines. I capped the three connections on the hydraulic block that went to the FEL and the one that went to the rear for the backhoe. The 3 point still will not lift except by hand.
Ok Harry, I got it now!! Have to draw me a picture..lolol. Guess I can't help in this regard. Hope 'ya find the cure!

Joe H.
 
   / 3 point hydraulics Max26 #5  
Can you post photo of what broke?
 

Tractor & Equipment Auctions

2000 CATERPILLAR 140H MOTOR GRADER (A51406)
2000 CATERPILLAR...
2015 DODGE RAM 1500 CREW CAB TRUCK (A51406)
2015 DODGE RAM...
KENWORTH T800 (A50854)
KENWORTH T800 (A50854)
**SALE ORDER ANNOUNCEMENT** (A51242)
**SALE ORDER...
2018 RoGator 1100C (A51039)
2018 RoGator 1100C...
2022 ISUZU NQR 18FT FLATBED (A51222)
2022 ISUZU NQR...
 
Top