My (year 2012) 4035 is fitted with the ML120 loader. The FEL dump/tilt function is sticking, causing the loader to continue its motion until I jiggle the joystick. My guess is that the cable is sticking and may need to be lubricated or replaced. Or perhaps the control valve block has accumulated gunk or rust over the years. Anything I need to be cautious of before removing this cable (small parts/springs that will cause something to fling-out)? Any tips or thoughts would be greatly appreciated. Also, are there after market companies that sell replacement cables, or should I bite the bullet and buy an expensive OEM?
Many thanks in advance for suggestions.
Mike
Many thanks in advance for suggestions.
Mike