jeremyrjensen
New member
Goodmorning,
I have been a creeper on the site for many years, searching for information when needed, and it has been a great tool and help for issues I've had in the past, as well as an outlet for information! Now, for my first post, I have a question I can't seem to find the answer too... and it seems like I had seen someone discussing this before, but can't seem to be able to find the post about it now!
What I have is a 4400 series utility tractor with a MMM I purchased that I am installing... as well as the attatching brackets and such. As I am getting this project compelete little-by-little... i have the small hydraulic cylinder that lifts the deck... it appears there are some clearance issues with a large main hydraulic line that is existing on the bottom ide of the tractor... essentailly a clearance issue with the MMM cylinder hitting this existing line on the tractor. I am sure someone has discussed this before.... would anyone have any input on this?
My other question is on the deck height adjustment knob... on the lower lift arms there is an elongated hole where the cylinder attatches to raise and lower the deck... under the elongated hole there is another single bore hole... is this where the deck height adjustment rod attatches to the lift arms?
Thanks!
I have been a creeper on the site for many years, searching for information when needed, and it has been a great tool and help for issues I've had in the past, as well as an outlet for information! Now, for my first post, I have a question I can't seem to find the answer too... and it seems like I had seen someone discussing this before, but can't seem to be able to find the post about it now!
What I have is a 4400 series utility tractor with a MMM I purchased that I am installing... as well as the attatching brackets and such. As I am getting this project compelete little-by-little... i have the small hydraulic cylinder that lifts the deck... it appears there are some clearance issues with a large main hydraulic line that is existing on the bottom ide of the tractor... essentailly a clearance issue with the MMM cylinder hitting this existing line on the tractor. I am sure someone has discussed this before.... would anyone have any input on this?
My other question is on the deck height adjustment knob... on the lower lift arms there is an elongated hole where the cylinder attatches to raise and lower the deck... under the elongated hole there is another single bore hole... is this where the deck height adjustment rod attatches to the lift arms?
Thanks!