Shut it off and when I went to start it again it won't start. I have checked all the connections all the lights work and come on but when you go to start it - nothing. New battery already and is good, connections there are clean so the only think I can think of is the brake safety switch but I have no idea of the location - anyone know where it is? Any other ideas that it might be? Seat safety switch? Is there any other safety switches? This tractor has driven me crazy. Had the **** drive shaft come off last week which broke a hydro hose, the whole tranny rebuild issue and now this- be ready to get rid of this tractor soon. Thanks for any recommendations.
5264 D won't start, safety switch locations.
- Thread starter Mlawson
- Start date
- Views: 2729
scoutcub
Veteran Member
- Joined
- Aug 19, 2008
- Messages
- 2,286
- Location
- Ohio
- Tractor
- Yanmar LX4900//Cub 7532//Cub Yanmar SC2400//Komatsu D38//Cub Volunteer//Cub SZ60/CAT 289C/CAT 308
Check to make sure the PTO switch isn't on. Brake pedal switch - sometimes requires extra force to make contact. Or check under seat for that switch continuity. Should be one of the 3.....
scoutcub
Veteran Member
- Joined
- Aug 19, 2008
- Messages
- 2,286
- Location
- Ohio
- Tractor
- Yanmar LX4900//Cub 7532//Cub Yanmar SC2400//Komatsu D38//Cub Volunteer//Cub SZ60/CAT 289C/CAT 308
If you follow the linkage, I think it's nder the center tunnel with a button or clip. I know some of the 5000's I've owned you have to really press the brake pedal, where the tab is bent a bit. Shoudn't be too hard to find....