Hello folks, a couple of things going on with my 5320:
Just recently when I start my 5320 the hazard lights come on and stay on for a minute or so even though the light switch is off. I checked my manual to see if this was some sort of service indicator but didn't find anything. Any ideas?
The second thing is that I'm a little concerned I may have over-greased the rear axle, when I was greasing everything last time each zerk on the rear axle took a lot of grease, and still I never saw any come through the hub, should it? I later noticed that the service interval on the rear axle zerks is much less frequent than the rest of them. Lately it doesn't seem to freewheel as readily as it did and I'm wondering if I screwed anything up in there by over greasing those. Thanks!
Just recently when I start my 5320 the hazard lights come on and stay on for a minute or so even though the light switch is off. I checked my manual to see if this was some sort of service indicator but didn't find anything. Any ideas?
The second thing is that I'm a little concerned I may have over-greased the rear axle, when I was greasing everything last time each zerk on the rear axle took a lot of grease, and still I never saw any come through the hub, should it? I later noticed that the service interval on the rear axle zerks is much less frequent than the rest of them. Lately it doesn't seem to freewheel as readily as it did and I'm wondering if I screwed anything up in there by over greasing those. Thanks!
