usmc
New member
on my 1992 843 bobcat, there are aux. hookups, but no linkages back at the pump. if anybody knows how this system works or what has to be done to make it work please advise.
843 bobcat aux. hyd.
- Thread starter usmc
- Start date
- Views: 5886
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
It is probably solenoid controlled by switches.
If you don't see any levers, then look for switches. Plug a motor in the AUX and see if any of the switches active the flow.
If you don't see any levers, then look for switches. Plug a motor in the AUX and see if any of the switches active the flow.
SSdoxie
Elite Member
843 works with mechanical linkage, move the right hand steering lever side to side to engage front Aux. There is a locking bolt/pin in the linkage behind the steering panel to remove if the lever will not move sideways. Raise the cab and look for a bolt/pin in the linkage going from the lever to the control valve.