Adjusting FEL Wedges

   / Adjusting FEL Wedges #1  

RoyJackson

Rest in Peace
Joined
Nov 17, 2001
Messages
23,144
Location
Bethel, Vermont
Tractor
John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
I've got to adjust the wedges on my 670.
Any body done this? The manual is fairly straight forward, but says to drop the front pin down 1" No picture of this and I see no movable pins forward.

Any tips, y'all?
 
   / Adjusting FEL Wedges #2  
I did this once on my 790 w/ 70 loader. It was pretty straightforward. As far as dropping the pins... make like you are going to remove the loader by releasing the latches, then lower the front support (raise the loader) just an inch. The front support will come off the tractor frame-mounted pins by an inch. Then loosen the wedge bolts, tap the wedges down and retighten. It's a lot easier to do than describe /w3tcompact/icons/smile.gif

15-43440-790signaturegif.gif
 
   / Adjusting FEL Wedges
  • Thread Starter
#3  
Thank You!!
 

Tractor & Equipment Auctions

BUSH WACKER ST-180 ELITE BATWING ROTARY MOWER (A51406)
BUSH WACKER ST-180...
2008 INTERNATIONAL 4300 M7 SBA 4X2 DUMP TRUCK (A51406)
2008 INTERNATIONAL...
100 GAL FUEL TANK (A50854)
100 GAL FUEL TANK...
RIGID TOOLBOX (A50854)
RIGID TOOLBOX (A50854)
PORTA CABLE 150 PSI AIR COMPRESSOR (A50854)
PORTA CABLE 150...
2008 INTERNATIONAL DURASTAR 4300 SERVICE TRUCK (A50854)
2008 INTERNATIONAL...
 
Top