bbfarm
New member
Had the tractor out after a long hibernation.
The lift arms on the loader are leaking. Before they would weep a little. Not at the seal & rod, but at the gasket where the the collar threads into and snugs up on the cylinder.
I'd like to torque it down with a pin wrench. It's 2 1/2" Cylinder. Spacing between the holes is ~ 2 1/8". Pin diameter is about an 1/8"
Where can I purchase a Pin Wrench? It appears nowhere in my vicinity. I'd like to think that if I can snug that collar up, the gasket will stop leaking.
This Loader was Mfg in 1999, does Allied/Buler use generic hydraulic cylinders. Would anyone know who's make. I sense a new seal kit is the next step.
The lift arms on the loader are leaking. Before they would weep a little. Not at the seal & rod, but at the gasket where the the collar threads into and snugs up on the cylinder.
I'd like to torque it down with a pin wrench. It's 2 1/2" Cylinder. Spacing between the holes is ~ 2 1/8". Pin diameter is about an 1/8"
Where can I purchase a Pin Wrench? It appears nowhere in my vicinity. I'd like to think that if I can snug that collar up, the gasket will stop leaking.
This Loader was Mfg in 1999, does Allied/Buler use generic hydraulic cylinders. Would anyone know who's make. I sense a new seal kit is the next step.
