Snowblower Allied yc5010

[angler83]

I'm a first timer here, so please a little paitence. Just recieved yesterday delivery of new snowblower from New Holland distributor. He said it was ready to go, but keep it oiled and greased. Today I opened the parts manual that was supplied, and couldn't find any zerks at all. not even on the pto joints and none were listed on the parts sheet. My only thoughts have been should I take everything apart to make sure it has been greased at dealer and manufactuer ( have bought implements before and had bad experences trusting some dealers to assemble proper.) before delivery to buyer. or just go ahead and use this season. Are all the bearings sealed on this unit? and what about the gear box?
I can grease the auger chain with motor cycle chain grease that you spray on but that seems little to do. any sugestions would be appreciated. and thanks for list
ning..

angler83

 

[Rocky Hoffler]

:cool2:I would contact dealer and ask them may have all sealed bearings don't know anything about snow blowers but I did mow the grass today about 82 degrees here