Morleys
New member
My AC H3 crawler stopped driving on the right side over about a 1 hour period of time while I was grading. It would only go in a circle to the right. I pulled the clutch from the right final drive housing which had a lot of water and grease in it. All of the teeth on the driving discs (fiber) were gone and the hub is not tight (has wobble when wiggled). Is this just a pilot bearing gone bad, or do I have other problems that would cause it to stop driving on the right side? I must have a worn seal on the drive shaft too with all the grease in the housing. I will replace the drive shaft bearings/seal, the pilot bearing on the clutch and the fiber discs. Anything else? Thanks