found a ford finish mower for my g152 tx1300, cleaned and greased it up and set it up for my tractor and in the process of testing it out i started smelling coolant so i pulled out of the field and shut it down right away raised the cover and my belt was only half of the original width. so i cut the belt off and i spun the alternator and i think my bearings are shot because it was really hard to turn. so can it be rebuilt or would i be better of replacing it. either way it goes im holding on to my tractor, its as handy as a pocket on a shirt. any tips, thanks in advance
alternator issue
- Thread starter agcotton
- Start date
- Views: 1062
RustyA
Platinum Member
There are still rebuilders in most areas. If they can't rebuild it they can usually get a new one cheaper than most parts stores. Not sure where you live but if you call a local Napa they should be able to refer you to a local rebuilders.
Roadworthy
Elite Member
If the only thing wrong with the alternator is the bearing you may be able to replace it yourself. If you do take it to a shop they can tell you whether it's worth rebuilding depending on the condition of the rest of the alternator.
Roadworthy
Elite Member
Belts are sized by length (or diameter) and width of belt. If you can't get the width off the belt measure the width of the V groove in the pulley. You can play it safe and take the old belt with you when you go shopping for a replacement.
found a top cog 15370 belt for it today installed it.seem to work fine caused i worked out in the field for awhile with finish mower. i also found out that the easiest way for me to install it was to save the bottom pulley for last. alternator spun fine but still looking to replace it. oh belt was from advance auto.
