Jan 21, 2008 / Assembly of parts for re installing injectors #1 K Kit New member Joined Jan 21, 2008 Messages 1 I have recently had the injectors rebuilt but confused in how to re-install them. There is a new steel gasket and a hard plastic or Teflon sleeve. As the steel gasket does not fit over the Teflon sleeve easily how is it reassembly? Kit
I have recently had the injectors rebuilt but confused in how to re-install them. There is a new steel gasket and a hard plastic or Teflon sleeve. As the steel gasket does not fit over the Teflon sleeve easily how is it reassembly? Kit
Jan 21, 2008 / Assembly of parts for re installing injectors #2 K kenmac Super Member Joined Feb 13, 2005 Messages 9,837 Location The Heart of Dixie Tractor McCormick CX105 Kubota MX 5100 HST, Kubota ZD1021, Kawsaki Mule 4010 trans 4x4 Have you asked the place where you purchased the parts how they should go in ? If you have a parts manual it may show the install
Have you asked the place where you purchased the parts how they should go in ? If you have a parts manual it may show the install
Jan 22, 2008 / Assembly of parts for re installing injectors #3 H HoyeTractor Gold Member, Approved Advertiser Joined Jul 11, 2002 Messages 1,097 Location North Texas Tractor Yanmar I don't know what model tractor you have but most of the YM series tractors are set up like this -- HEAD: Yanmar Tractor Parts #33s are copper washers #34 is a "plastic" washer. Hope this helps, Aaron Parts@HoyeTractor.com (940)592-0181
I don't know what model tractor you have but most of the YM series tractors are set up like this -- HEAD: Yanmar Tractor Parts #33s are copper washers #34 is a "plastic" washer. Hope this helps, Aaron Parts@HoyeTractor.com (940)592-0181
