Dick_Jermyn
Bronze Member
This is great humor guys, keep it up. We are watching for the final outcome.
BAD PULLEY!!!! "BAD" PULLEY..
- Thread starter NCGMAN
- Start date
- Views: 3279
oliver28472
Veteran Member
One thing about your deck that looks different than a Woods is the center brace bar coming down from the top link to the center of the back of the deck. Have not seen that on any Woods. Does it have a gear box?
OP
NCGMAN
Bronze Member
Yes it does. I have everything off for painting and replacing..
gear box: Superior,,, Stockton, MO.
gear box: Superior,,, Stockton, MO.
OP
NCGMAN
Bronze Member
Well I finally got the roll pin out of the bushing (shim)?? and shaft. The bushing is what holds the bearings in. I used my punch as far as it would go!!!! Looked and looked for something to use (to cheap to buy a smaller one). Picked up an allen wrench, kinda hard to drive it with the bend, so I cut it off and made a flat edge. This stuff is kinda strong.. Punched that roll pin right out!!!! Now have to take to a press and get bearings out.... SEE, TOLD YA!!!!!!!!!
oliver28472
Veteran Member
We got that far. Let us know how easy it is to press out the shaft. hehehe.
OP
NCGMAN
Bronze Member
Hey LOOK!!!! My picture did download.... Now,, Them was the days!!!
See the peanut stacks in the field behind me. That was the way they were dried in the "old" days. I remember going over and eating my fill....
With a press the bearing should come out "easy"...
See the peanut stacks in the field behind me. That was the way they were dried in the "old" days. I remember going over and eating my fill....
With a press the bearing should come out "easy"...
