I bought 710 recently with a stuck clutch. I put it in a vise with a socket (with larger ID than the splined section) between the vise jaw and the plate with the holes that surrounds the splined section. Doused it repeatedly yesterday and then again today with Power Blaster spray. Cranked down on the vise and it did not move. Continued to spray PB, increased pressue on the vise and lightly tapped on the outside of the conical section with a hammer. After repeatedly doing this for about 20 minutes, the clutch suddenly released. This is the second conical BCS clutch I have rescued using this method.
Bill in NC
Bill in NC
