Hi guys I was interested to know if anyone has replaced the belt that drives the bale loader pickup on a 1012. The new Holland parts list quotes the number 523946 that is no longer available .Could anyone tell me the length of the belt if they replaced it with a non genuine one please Thanks Vic
Belt for NH1012 Bale wagon
- Thread starter lachdunc
- Start date
- Views: 2358
TSC has these belts. NLS usually means the dealer has it on a shelf somewhere out in front. TSC has these, too. Use a piece of twine to measure the length if yours is old and blowed out.
Now that is one nasty job to replace that belt, so buy a tuff green one. Its worse than the belt on a 479 mower sickle drive. Basically, torch, pry and curse the danged think apart. Don't hurt that big cast pulley on the main cross conveyer....
Now that is one nasty job to replace that belt, so buy a tuff green one. Its worse than the belt on a 479 mower sickle drive. Basically, torch, pry and curse the danged think apart. Don't hurt that big cast pulley on the main cross conveyer....
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,143
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
Inside diameter 140"
Outside diameter 142.8"
top width .656"
thickness .438"
crosses over to a CaseIH p/n 593892R1
Outside diameter 142.8"
top width .656"
thickness .438"
crosses over to a CaseIH p/n 593892R1
art
Super Member
Did a quick check here and both numbers were bad! The NH numbe show's to the baler but nothing to supercede to.
