Bent BX 3-Point Lift Arms - Anyone Replaced Thiers?

[walker450]

I know I know it is all my fault I guess I backed into something too hard. I have no idea when I done it but I noticed my right side three-point lift arm was bent really bad.

I bought a new one and will be replacing it this week. Anyone done this before? Any advice before I tear into it?

Thanks in advance!

 

[Code54]

Should just swap right out. Just check all the other parts as you go to make sure nothing else is bent. I had a B series that I bent the arms on (was busy getting stung by a ton of ground wasps and bailed without setting the break - sort of rolled into a tree -oop's)

The parts were not cheap but the job was easy.

 

[Code54]

Also take a photo before you pull anything apart just in case you can't remember exactly how something goes if you are not comfortable with the disassembly.

 

[walker450]

Thanks Code!

Turns out this was extremely easy. Kubota already thought about this one! I was done in a couple of minutes. It's so simple no explanation is necessary. Anyone should be able to figure it out if they just look at it for a moment. (what I should have done before posting, lol)

 

[Code54]

Anytime - always better to ask first just in case there is a trick to it. Glad it worked out!

 

[mjym]

ya it happen to me and bought a new one and get the old one fix on a press so i have a spre one