bobcat 610 roto swivel rebuild

[woodie50]

I think I asked this question in the wrong forum so I will try again in the right
place...hydraulics. I put a new belt on my bobcat 610 and when I put the
swivel line back on the drive pulley, I think something fell out. I changed the
belt on my lawn so therefore whatever it was I couldn't find it. When I started
the engine and hit the speed control, fluid came out of the swivel fitting and
I had no pressure to move the split pulley. I hope someone can tell me if what
I dropped. I think it must have been some sort of seal or washer. Thanks.

 

[J_J]

A parts manual break down would be your best bet.

 

[woodie50]

I tried at the local dealer, but it really doesnt show whats there. I ordered a
seal kit and two parts I think I am missing. Thanks for the reply.

 

[woodie50]

Ok. got it fixed. It was a seal in the roto swivel that fell out when I took it off
to change the belt. After doing this job, I will never work in the dirt and grass
again. I at least got the whole thing rebuilt and it works great.

 

[CharlieNH]

My roto-swivel is leaking slightly and I'm thinking of taking it apart. Was that seal just an O-ring or was it something fancier? How much did it cost?

I think I asked this question in the wrong forum so I will try again in the right
place...hydraulics. I put a new belt on my bobcat 610 and when I put the
swivel line back on the drive pulley, I think something fell out. I changed the
belt on my lawn so therefore whatever it was I couldn't find it. When I started
the engine and hit the speed control, fluid came out of the swivel fitting and
I had no pressure to move the split pulley. I hope someone can tell me if what
I dropped. I think it must have been some sort of seal or washer. Thanks.

 

[woodie50]

Sorry I took long to answer...that little piece was $20 . It looks like a little
hat and fits between the roto swivel and the orfice that feeds the pulley.