bottom plow for small Kubota?

[dex3361]

Is the plow point missing? It seems like there is a piece missing from the leading edge of the plow?

 

[Scotty370]

I suspect the point is fine, just tucked under the dirt/gravel floor of the garage/shed......
My only concern other that weight,(Loaded Tires, etc) would be the tires themselves. You appear to have the 'Industrial Skid-Steer' type that I have. and they're no where near the aggressive cleat of a regular Ag Tire. At least that's been my experiance........~Scotty

 

[NFPeterA]

I measured the share (blade) today. It's 21" from front tip to end. The top of the moldboard is 27" horizontally and the face of the moldboard is 19" from the edge of the blade to the top of the board. That's got to be way too big a plow for this little tractor. However, I did manage to plow two experimental furrows in wet ground over the Christmas holidays... More photos of the plow are appended. Comments? Thanks again to all of you who have provided comments. Peter

 

[Scotty370]

Hey, You don't have to sink the whole thing in the ground! With the coulder wheel cutting and the thing set up right, I'm thinking that you could just cut a furrow 8-10" deep! I'm learning to! Chime in folks! ~Scotty