have a J.D. 535 baler, was baling Saturaday, went to dump and one of the gate latches didn't open and I didn't know it, so when I put preasure on the hydrolics i must have sprung the gate, because now it won't latch. I can't spot a bend on ant of the parts but when you try to latch it the catch on the side taht opened origionly won't close all the way. The cylinder bottoms out in the slot where the pin that holds the upper end connects to the baler by about a half inch or less, but like I stated can't see any bent parts, I was just checking to see if any one else had had this problem.
Thanks in advance
Thanks in advance
