Brush guard for Kubota RTV 400

[M5farms]

Didn't like the way the factory ones were made. I built this one this weekend. after I got this installed I had to go back and pull it out 3" so the hood would open. ill post updated photos once I get it painted

I picked up the headlight cover extentions at the truck accessory shop for 25 bucks. the 1x2 tube cost me about 15 bucks

.[/quote]

 

[OrangeBuggy]

It looks good, nice job.

 

[DIXIEDOG]

Good job, that should work well. If you decide you prefer the closer look you can always use a couple pins to allow it to pivot like most manufacturers do...

Bolt in the bottom and a pin up top on each side so it pivots out a few inches for the hood to open