Backhoe BX23 backhoe dismount catches fender? Plastic side shrouds...

timswi · Mar 26, 2009

I had the same issue when I got mine...The main thing is to roll the BH so it's on an angle, if not...it will hit the fenders...The last picture above is usually what is missed...I still forget on occasion. It's a tight fit, but it does clear.

Keep the outriggers at 18" off the ground during the whole procedure...would hate to see the BH roll over if it sunk in the dirt!!!!

Good Luck!!!

rdsaustintx · Mar 28, 2009

x3. The absolute key is to angle it *way back* clear of the sheet metal before lifting it with the outriggers. I put it probably twice as tilted as Bernie shows. Put it back on the same way.

Don't feel bad. Tried doing it the way the manual says the first few times and my tail lights will never be quite the same.