Snow BX2753 Driveshaft - For Snowblower

[keytonbarrone]

Hi everyone

I recently was fortunate enough to get a really good deal on a BX2750B snow blower and BX2751 quick hitch. This will be a huge improvement for my snow removal process over my current method of using a back blade. Sometimes there's just too much snow to pull behind the tractor on my 150 yd driveway.

Unfortunately the person I bought it from had it on a BX2200 which used the 3.5" shorter BX2752 driveshaft. I'm looking for a BX2753 driveshaft. I've seen posts from years past where folks are looking to swap or sell - checking to see if anyone is out there at the moment? Kubota # 70060-02186.

I have not found any for sale on craigslist or FB. If nothing pops up I'll either bite the bullet on Messick's for a new one or look at having a driveshaft shop extend my current shaft.

 

[diesel85]

Without going through my service books, but I think the involute spline count and shaft is the same size.

If it hooks up, you can take it to a reputable machine shop and they can extend it and re-balance it. Might as well have them stake new u-joints in it too while you got it all apart.

I've extended shafts for trucks when needed and then throw it on my lathe for run out.

Going rate around here is about $50 for small shafts.