NM_Mike
Member
Howdy,
I recently joined this excellent group after lurking for years. I just purchased the Jinma 6" chipper. After assembling the unit (with help from this forum, thx), I finished early enough to run a 5" pine tree through it before the sun went down. Man am I surprised!! The chipper sucked it in without belching a bit. The only complaint that I have at this time is the chip size seems to be 3/16 to 1/4 in thickness. Is there any way to thin the chip size down a bit?
thx again for all your help,
Mike
I recently joined this excellent group after lurking for years. I just purchased the Jinma 6" chipper. After assembling the unit (with help from this forum, thx), I finished early enough to run a 5" pine tree through it before the sun went down. Man am I surprised!! The chipper sucked it in without belching a bit. The only complaint that I have at this time is the chip size seems to be 3/16 to 1/4 in thickness. Is there any way to thin the chip size down a bit?
thx again for all your help,
Mike
