Cylinder reseal, rod end bushing replacement

[joea99]

The bushing in the rod end eye was bad, so pressed in new ones. Question is, "flush" good enough or should they be pressed in a little bit further?

WSM does not bother to say and I cannot see the ones on the machine without pulling the pins.

 

[joea99]

The bushing in the rod end eye was bad, so pressed in new ones. Question is, "flush" good enough or should they be pressed in a little bit further?

WSM does not bother to say and I cannot see the ones on the machine without pulling the pins.

Eh, it'll work either way. Sez I. And it does.