deere 214t baler

[donais]

i got a new bushing for the shear bolt on the flywheel. how does it come out? press it, beat it? take the flywheel off or?? i guess i ordered a new one so might as well change it

 

[Tx Jim]

Big hammer & elbow grease with flywheel attached to baler

 

[DaveOmak]

Are you speaking of the 1/4" bolt that holds the flywheel in position to the shaft ??? If so, push it out from the front with a new bolt... In the ear there should be an indent for the bolt head.... On my 14T that is the way it is put together.....

 

[donais]

its the bushing that the bolt goes in.the bushing is has 1/4 inch hole about 1 inch od. i was wondering if i need to pull the bushing out or just beat it through. so far im gonna use the hammer elbow grease method.

 

[Tx Jim]

As long as the shear bolt arm that's splined to the gearbox is not blocking the travel of the bushing while attempting to remove the bushing can be driven towards the baler.

 

[donais]

oh cool thanks.

 

[Tx Jim]

Here's you a parts breakdown. Parts key #11 is the shear pin arm I was referring to

 

[donais]

im changing # 7

 

[Tx Jim]

Yes #7 is the replaceable bushing that requires a big hammer.

 

[macecase]

im changing # 7

Where did you get that bushing? Or, what size is it? Does it have the hex shape in it to hold the bolt head? Mine seems to be stripped.