Deere 5210 7-Pin Trailer Plug

[jgbanshee]

I have the factory 7 pin round trailer/implement plug on the back of my 5210. I am looking to get 12V from it from one of the two accessory pins but there is no power at them. Does anyone know where the relay is or should be located for this? Thanks

 

[JD5210]

I hope this 5X10 wiring diagram helps you.

 

[workinonit]

Interesting. I could have sworn my 5310 had switched power and full time power. I could be confusing it with my new tractor but...that's not what that WD says.

 

[JD5210]

I hope this helps as well.

 

[jgbanshee]

Thanks JD5210. I have this info but I cannot physically locate the relays. Are they behind the instrument cluster?

 

[workinonit]

If they aren't in the fuse block they are behind the instrument cluster.

 

[JD5210]

Thanks JD5210. I have this info but I cannot physically locate the relays. Are they behind the instrument cluster?

If I remember correctly they can be found by removing green panel to the left of the instrument cluster. Looking at jdparts.com it looks like the part number is LVA13729. There 2 relays with the small part number, so for testing you should be able to switch them around.