gsganzer
Elite Member
- Joined
- Jun 11, 2003
- Messages
- 4,022
- Location
- Denton, TX
- Tractor
- L3800 w/FEL and BH77, BX 2200 w/FEL and MMM
When I ran a fab shop, all our AWS D1.1 (structural carbon steel) was GMAW-P, no flux core. With a fab shop, most steel is new and stringent weld prep is pretty standard, so less need for the flux core to float out the impurities. I just set up my welder at home for .035 GMAW with C25, but I've been looking to swap to a FCAW-G to deal with some dirtier stuff for building some trusses.
