Fan Blower Switch or Fan replacement
- Thread starter Kurtis22
- Start date
- Views: 4336
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 10,686
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
Did you check the #7 fuse that is under the operators seat?
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,889
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
If you are sure is the switch, put a temporary jumper across it.
I did.
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 10,686
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
The service manual is pretty vague on troubleshooting. Pull the panel where the switch is located. You should have power on one wire when the switch is off. The manual then says that power is fed to another terminal when L-M-H is selected. Power is also fed to the individual LMH terminals for a total of 5 terminals. If you switch has power and seems to be working, check power and ground at the blower.
