RProv
Member
I知 finishing adapting a Kubota LA402 FEL to my Bolens/Iseki G194/TS1910F. Found the loader in
the junk yard on it痴 tractor after the tractor had been in a fire. Unfortunately someone had gotten the
bucket before me but I found a B1616 bucket on-line. I adapted the Belly bar to bolt on to the
mounting bosses on either side of the bell housing. I adapted the front brace that goes from the towers
to the front frame. Plumbed up the hydraulics and it works. I have only to run the two rear bars that go
from the belly bar back to the rear axle assembly.
My question:
What do you guys think of triangulating the two rear bars back to the 1 pin that the rear hitch attaches
to? The 5 OEM plow blade was triangulated back to this and it is a pushing machine. In snow or dirt
it will push like ****. It痴 attached with two pins to the front and two box tubing bars go back to the 1
pin on bottom of rear end. I figure if it痴 good enough for the plow than it痴 ok for the FEL. What say
you?
Thanks,
Rich
the junk yard on it痴 tractor after the tractor had been in a fire. Unfortunately someone had gotten the
bucket before me but I found a B1616 bucket on-line. I adapted the Belly bar to bolt on to the
mounting bosses on either side of the bell housing. I adapted the front brace that goes from the towers
to the front frame. Plumbed up the hydraulics and it works. I have only to run the two rear bars that go
from the belly bar back to the rear axle assembly.
My question:
What do you guys think of triangulating the two rear bars back to the 1 pin that the rear hitch attaches
to? The 5 OEM plow blade was triangulated back to this and it is a pushing machine. In snow or dirt
it will push like ****. It痴 attached with two pins to the front and two box tubing bars go back to the 1
pin on bottom of rear end. I figure if it痴 good enough for the plow than it痴 ok for the FEL. What say
you?
Thanks,
Rich