finished pictures of fenders.

[TOMMYHPX4X4]

here are the pictures of a finished fender. i opted not to put the tail light for now. i'm gonna wait to piant them til i get both sides finished but this is pretty much how they gonna look.unless i change something .i made them about 1" wider than the stock ones so they cover more "less mud flying all over" plus i came down a bit lower with mine in the rear to keep mud from caking up on the bed.

 

[TOMMYHPX4X4]

i changed them around a bit today and bolted them up all the way and load tested them by standing on them they didn't even move and i weigh 140lbs so i would say anyone who weighs 150lbs or less can use them as a step to get into the bed if need be because they are tough. the final price is gonna be 225.00 for a seti know some will say thats high but they take up alot of aluminum and the 4x8 sheet is 259.00 now you add in the aluminum wire /argon gas/ electricity/buffing pads/ primer/paint /time thats cheap john deere sells them plastic ones for 55.00 plus you have to pay shipping so your lookin at around 65.00 plus for plastic that you can't stand on. i'm gonna be priming and painting these tomorrow and then they are going into my stack of stuff for ebay. i'll post some pictures of them when they are all painted up and finished.i have another bumper for the hpx/xuv too thats gonna be up for sale tooit's going for 200.00.