I have a Ford 1920 and would like to add dual remotes to the rear. I do not have a loader and the tractor is kept 60 miles from my house.
Looking at the Service manual it looks like I could add the remotes by accessing The two ports of the Combination System Relief and Diverter Valve Manifold. The manual does not say what size Hoses connect to high pressure port and return port.
The main Control valve is harder to access buy is doable.
Yesterdays tractors show two Ford 1920 Hydraulic valve kits, HV4020 and Hv4124. HV 4020 seems straight forward but they have no information on how it connects to the tractor, hose sizes ( looks like is 1/4 NPT) or anything else.
The HV4124 seems to be a remote stand alone kit that would attach to a fender or where the loader controls would be located. Again no information what to connect it to or size of fittings.
I did call them but after holding for about an hour they could provide no information other than what was in the catalogue.
Thanks in advance Mike from NC
Looking at the Service manual it looks like I could add the remotes by accessing The two ports of the Combination System Relief and Diverter Valve Manifold. The manual does not say what size Hoses connect to high pressure port and return port.
The main Control valve is harder to access buy is doable.
Yesterdays tractors show two Ford 1920 Hydraulic valve kits, HV4020 and Hv4124. HV 4020 seems straight forward but they have no information on how it connects to the tractor, hose sizes ( looks like is 1/4 NPT) or anything else.
The HV4124 seems to be a remote stand alone kit that would attach to a fender or where the loader controls would be located. Again no information what to connect it to or size of fittings.
I did call them but after holding for about an hour they could provide no information other than what was in the catalogue.
Thanks in advance Mike from NC
