strum456
Platinum Member
I split my 7600, mainly because the PTO doesn't stop turning. It turns out that the problem was a small pin that holds / tensions the band. This lower pin holds the band to a lever that is actuated by the brake piston. The upper pin is held in by a cotter pin. The lower pin is held in by nothing??? I found it laying in the bottom of the case.
I also noticed that the backlash on the ring / pinion seems excessive. I cannot find any information in the book describing the tolerances for the backlash or how to adjust it. Are there shims somewhere?
I also noticed that the backlash on the ring / pinion seems excessive. I cannot find any information in the book describing the tolerances for the backlash or how to adjust it. Are there shims somewhere?