Pat's Easy Change Ford Disc Plow Model 10 - 475 S/N 1226

[Pappy54]

Could anyone direct me towards a replacement "cross shaft" for a Ford Model 10-475 disc plow? I have been unsuccessful in identifying parts for this particular model and was wondering if other Ford models would interchange. Appreciate any help or suggestions you might offer.

 

[Shaneard]

If you can't find one you may have to cut that end off, make a flat plate with the proper offset and weld it to your shaft and install a lower link pin like this.CountyLine Lower Link Pin at Tractor Supply Co. That shaft should be cast steel and easily weldable.


Here's a photo of what I'm talking about. http://dlnjumhieeujc.cloudfront.net...d4bd30e9/d84fc78714374039be41b8b011f5b7b8.jpg

 

[Pappy54]

Shaneard - appreciate the tip. More than likely that is the avenue we will need to pursue. Was hopeful however there was one laying around somewhere that we could buy. Thanks again.