Oil & Fuel Fuel filter
- Thread starter Sawranch
- Start date
- Views: 1701
Coyote machine
Super Member
- Joined
- May 4, 2009
- Messages
- 7,641
- Location
- Southern VT
- Tractor
- 22 SANY SY 50U, '10 Kioti DK 40se/hst KL-401 FEL, loaded tires, KB-2485 bhoe, Tuffline TB160 BB, Woods QA forks, MIE Hydraulic bhoe thumb & ripper tooth, Igland 4001 winch, & GR-20 Log Grapple. Woods BBX72" Brush Mower. Diamondplate aluminum canopy
Is it possible to fill the bowl and filter and then attach them back to the housing? There is also a petcock which can be used to not allow air into the lines, but I think you missed that opportunity, but perhaps not. I seem to remember it is on the filter housing where the bowl attaches. See if either of those ideas help....
VictorW
Veteran Member
Check this post a few weeks ago about a DK45. It should help. Dk45 won't start after fuel bowl change - TractorByNet.com
PoorMansCat
Platinum Member
just dont use ether... its really easy to tear up a starter or blow a head gasket using ether on little engines.
8404
Gold Member
On top of my fuel bowl is a ON,OFF, airbleed. switch. when i finish tightening the fuel bowl i set the switch to AIRBLEED and let the bowl start filling up by gravity when its half full i will start the tractor and when it compleatly full i then switch it to the ON possition. and doing this i never get air into my fuel lines..
VictorW
Veteran Member
You probably didn't get air into the lines from the injector pump to the injectors themselves. I believe if you did, you would have had to crack each line at the injectors and turn it over to get the air out. Usually the air in that portion of the line will compress before the injector opens making it hard to bleed out the air until you crack the line to let it escape. It's good you're up and running.