Oil & Fuel fuel gauge
- Thread starter dvarner
- Start date
- Views: 1946
kenmac
Super Member
- Joined
- Feb 13, 2005
- Messages
- 9,835
- Location
- The Heart of Dixie
- Tractor
- McCormick CX105 Kubota MX 5100 HST, Kubota ZD1021, Kawsaki Mule 4010 trans 4x4
my fuel gauge is built into the fuel tank cap. I don't know if this set up will work on your 2700 or not. Mabe someone that sells parts will know
chriswheeler
Platinum Member
JD 950 ( yanmar made ) has a sender in the tank and a gage on the dash. That said, think you would need the tank, sender, and gage from a 950,1050 IF it would fit. Lots of trouble. I'd go with the in cap gage if you can. I have one in my YM 3000 ( in the cap type ) and it does give you some idea how much fuel you have. In the dash type could run lots of bucks and lots of trouble with the install if it would fit. Don't think you could just cut a hole in the existing tank and get the sender to seal again.
Chris
Chris
NCGMAN
Bronze Member
Just put a post it on the dash to remind yourself to check the fuel 
