thepumpguysc
Elite Member
Donc.. did u get it to start.?? Loosen the bleed screw on the side of the inj. pump, by the name plate..
Operate the hand primer or spin the engine till u get fuel & no air coming from the bleeder screw & tighten the screw.
Loosen ALL 3 of the steel lines at the injectors & spin the engine till fuel squirts out & tighten.. it should start then..
IF NOT> take the fuel line off going into the back of the inj. pump.. fill the endplate up w/ fuel.. now crank the engine..
Did the fuel go down any.?? if yes, thats good, u didnt seize the pump..
IF NO, bummer, u seized the inj. pump..
Operate the hand primer or spin the engine till u get fuel & no air coming from the bleeder screw & tighten the screw.
Loosen ALL 3 of the steel lines at the injectors & spin the engine till fuel squirts out & tighten.. it should start then..
IF NOT> take the fuel line off going into the back of the inj. pump.. fill the endplate up w/ fuel.. now crank the engine..
Did the fuel go down any.?? if yes, thats good, u didnt seize the pump..
IF NO, bummer, u seized the inj. pump..